Actiontec electronic 56K V.90 - Manual (Page 65)

64
%B View Numbers in Blacklist
If blacklisting is in effect, this command displays the numbers for which the last call
attempted in the past two hours failed. The ERROR result code appears in countries
that do not require blacklisting.
%Cn Enable/Disable Data Compression
Enables or disables data compression negotiation on an error corrected link.
d n a m m o C t c e ff E
0 C % n o i s s e r p m o c a t a d s e l b a s i D
1 C % n o i s s e r p m o c a t a d 5 P N M d n a s i b 2 4 . V h t o b s e l b a n E
Result Codes:
K O 1 , 0 = n
R O R R E e s i w r e h t O
AT Commands for Testing and Debugging
The following commands are to be used for testing and debugging only and are not
meant for general use.
&&C Write to/Read from DSP Register
d n a m m o C t c e ff E
- > c o l < C & & T A
> l a v < ,
. > c o l < n o it a c o l t a r e t s i g e r P S D o t > l a v < e u l a v e h t s e ti r w
> c o l < C & & T A . > c o l < n o it a c o l m o rf s d a e r
&&L Line-to-Line Loopback
This command provides a loopback for line-to-line.
&&R Write to/Read from DSP RAM Location
d n a m m o C t c e ff E
-, > c o l < R & & T A
> l a v <
> c o l < n o it a c o l M A R P S D o t > l a v < e u l a v e h t s e ti r w
> c o l < R & & T A > c o l < n o it a c o l m o rf s d a e r