Sensor assembly instructions—stage1, Model ph87 retraction sensor assembly – Yokogawa pH/ORP Retractable PH97 User Manual

Page 4

IM M1263JL-A

Sensor Assembly Instructions-Stage1

BEGIN STAGE #1 ASSEmBLy OF ThE mODEL Ph87 By FOLLOwING ThE STEP-By-STEP
INSTruCTIONS [A] ThrOuGh [F] IN OrDEr AS ShOwN BELOw:

Sensor Assembly Instructions—Stage1

REFER TO PAGES 15 AND 16 OF THE
SENSOR ASSEMBLY AND ITEMIZED PART
LIST FOR ALL THESE COMPONENTS.

Model PH87 Retraction Sensor Assembly

PLEASE NOTE

REFER TO PAGES 16 AND 17 OF THE
SENSOR ASSEMBLY AND ITEMIzED PART
LIST FOR ALL THESE COMPONENTS

[STEP B]. SLIDE
PACkING GLAND, ITEM NO.3, ONTO
SHEATH, ITEM NO.4. kEEP LOCkING
NUT AND FERRULES LOOSE BUT
ATTACHED TO PACkING GLAND

[STEP A]. INSTALL
PACkING GLAND O-RING, ITEM NO.
3d, INTO PACkING GLAND BODY,
ITEM NO. 3c.

[STEP D]. THREAD SENSOR
CABLE THROUGH SHEATH
AND SLIDE THE SENSOR
INTO SHEATH UNTIL IT STOPS
AGAINST FLARED END

[STEP C]. STRETCH O-RINGS,
ITEM NO. 2, INTO GROOVES
ON SENSOR

[STEP F]. THREAD SENSOR
CABLE THROUGH COUPLER
TUBE, ITEM NO. 1, THEN SLIDE
COUPLER TUBE INTO SHEATH
UNTIL IT CONTACTS SENSOR.

[STEP E]. STRETCH O-RING,
ITEM NO. 1a, INTO GROOVE ON
COUPLER TUBE, ITEM NO. 1.

FLARED END
OF SHEATH

This manual is related to the following products: