Wright Serial #59542 and higher - Manual (Page 28)

26
This symbol means ATTENTION! YOUR SAFETY IS INVOLVED. The message that
follows the symbol contains important information about safety. Carefully read the message.
This Roll Over Protective Structure (ROPS) has been certified to industry and/or government
standards. Any damage or alteration to the ROPS, mounting hardware, or seat belt voids
the certification and will reduce or eliminate protection for the operator in the event of a roll-
over. The ROPS, mounting hardware, and seat belt should be checked after the first 100
hours of machine operation and every 500 hours thereafter for any evidence of damage,
wear, or cracks. In the event of damage or alteration, the ROPS must be replaced prior to
further operation of the machine.
The seat belt must be worn during machine operation when the machine is equipped with a
certified ROPS. Failure to do so will reduce or eliminate protection for the operator in the
event of a roll-over.
Substitution of mounting hardware, seat belt, etc, with components not equal or superior to
the original certified components will void the certification and will reduce or eliminate
protection for the operator in the event of a roll-over.
All labels, caution decals, ROPS certification data, etc. must be kept intact and legible.
9. If ROPS is a folding ROPS, ROPS should be in the upright position and pinned when operating the
machine.
10. See General Safety Information below;