Wright Serial #59542 and higher - Manual (Page 27)

25
WARNING
WARNING
6.10 Cutting Blades
In order to maintain to best cut, it is important that the blades are well sharpened and not damaged. Bent or
cracked blades or blades with large nicks need to be replaced. Blades must be balanced after sharpening.
To change the blades;
•
Stop engine, remove the key and wait for all moving parts to stop.
•
Engage parking brake.
•
Lift front of mower and secure in the raised position with jack stands.
•
Remove the blade bolt by turning counterclockwise.
•
Apply anti-seize to the blade bolt.
•
Install new or re-sharpened blade, start mounting bolt by hand.
(Ensure the blade spacers are reinstalled with the same Qty and location)
•
Torque blade bolt 70-80 ft lbs
6.11 Transporting / Tie Down Locations
Use a heavy duty trailer or truck to transport the ZTO . Lock brake and block wheels. Securely fasten the
unit to the trailer or truck with straps, chains, cable or ropes.
o Fasten unit to trailer or truck using tie down locations shown in photos.
6.12 Loading and Unloading
Use extreme caution when loading or unloading units on/off trailers or trucks. One full width ramp that
extends beyond the rear tires is recommended rather than individual ramps for each side of the unit. The
ramp should be long enough so that the angles between the ramp and the trailer or truck does not exceed
15 degrees. A steeper angle may cause the mower deck components to get caught as the unit moves from
ramp to trailer or truck. Always put the deck in the transport (up & locked) position when loading or
unloading. Never attempt to turn the mower around on the ramp. Avoid sudden acceleration when driving
up a ramp and sudden deceleration when backing down a ramp.
6.13 ROP’s Installation & Operation
– P/N 98410135
IMPORTANT when using a ROPS:
1. DO NOT cut, drill, modify or repair ROPS in any manner.
2. Always replace a damaged ROPS.
3. Always use the seatbelt and ROPS together.
4. Frequently inspect roll bar and seat belts for damage or loose hardware.
5. Use extreme care when working close to fences, ditches, trees and on hills.
6. Check overhead clearances carefully before driving under any objects.
7. DO NOT leave operator’s position while unit is running.
8. DO NOT carry riders.
Front
tie
down
Rear tie down