Wright Serial #59542 and higher - Manual (Page 18)

16
4.7 Deck Lift Lever
The foot operated deck lift is used to raise and lower the deck.
Deck is to be in the up position when in transport, go over curbs,
loading and unloading on to a truck or trailer. The ZTO has a deck lift
assist spring but optional Deck Lift Foot Lever Extension Kits are
available thru all Wright Dealers. (P/N 95460011)
4.8 ROP’s
A Roll Over Protection System (ROP’s, P/N 98410135) and seat belt is provided with the Wright ZTO. Do not
remove the ROP’s and the seat belt.
•
Inspect ROP’s and seat hardware after the first 100 hrs of operation
and every 6 months for loose or missing hardware.
•
Inspect the seat latch to make sure it is functioning properly.
•
Make sure Retaining ring and clevis pin are fully installed and lanyard is
in good condition.
•
Keep ROP’s fully extended.
•
Use seat belt
4.9 Safety Switch System
The Wright ZTO is equipped with a safety interlock system. The PTO must be disengaged, an operator in the
seat and the control levers in the Out (Brake On) position in order to start the machine.
Deck
Lift
Lever
Retaining
Ring
Pull Pin
w/
spring
Seat Up Switch
Mower will not start with
seat in the “Up” position.
Control Handle Safety switch
Control handles must be in the
out position to start the mower
and to leave the seat
Seat (OPC) Safety Switch
Operator must remain seated
while blades are engaged. To
leave the seat, disengage blade
switch and move the control
arms to the outward
(Brake/Parked) position.