2 warning, safety and instructional decals, 3 specifications – Wright Serial 54956 and higher User Manual
Page 13

12
76490013, DECAL, MAIN INST. PANEL
2 Warning, Safety and Instructional Decals
•
Specific safety warning decals are located on the equipment near immediate areas of potential hazards.
•
Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and instructional decals.
•
Replace worn, damaged or missing safety decals.
•
If an attachment or accessory has been installed, make sure current safety decals are visible.
1. Blade engage/disengage switch
2. Ignition switch, Off
3. Ignition switch, Run
4. Ignition switch, Start
3 Specifications
Engine
•
See your engine owner’s manual
•
RPM: Full speed 3600 +/- 50 RPM (no load) / Idle: 1550 RPM
Electrical System
•
Charging System: Internal stator coil
•
Battery Type: Maintenance free
•
Battery Voltage: 12 Volts
•
Fuses: Two, 20 amp blade type
1
2
3
4
76490005 DECAL, THROTTLE INSTRUCTIONS
Throttle, Fast/Full
Throttle, Slow/Idle
Steering controls
76460001 DECAL, DANGER
BLADE HAZARD
76490001 DECAL,
SHIELD MISSING
76490053 DECAL,
PARKING BRAKE