Pfister GT48-CB0Y - Manual (Page 3)

DRAIN BODY INSTALLATION
7 9
10
8
11
7 SECURING FAUCET
Place Faucet (7A) to sink surface. From underneath sink, secure Faucet using Wingnuts
(7B). Hand tighten.
8 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (8A) to Faucet Inlets (8B). Hot water supply lines go into
left inlet. Cold water supply lines go into right inlet. (Supply lines are not included).
Please follow manufacturer’s instructions when installing suppy lines.
9 POP-UP ROD CONNECTION
Insert Lift Rod (9A) into hole at the back of Spout (9B).
10 POP-UP INSTALLATION
Install and adjust Pop-Up (10A) using separate instructions supplied with the Pop-Up
assembly.
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
3
10A
7A
7B
7A
7B
7B
9A
9B
HOT
COLD
8A
8B
8A
8B