Pfister GT72-YP2Y - Manual (Page 4)

E
N
G
L
IS
H
ENGLISH
ENGLISH
MAINTENANCE & CARE
13 16
14
15
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased your faucet.
2. When replacement parts are not available, please write or call Price Pfi ster Consumer
Service.
3. Always turn off water and relieve pressure before working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative fi nishes, use only a soft damp cloth to
clean and shine. Use of polish, detergents, abrasive cleaners, organic
solvents or acid may cause damage. Use of other than a soft damp
cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are
not acceptable for public areas or Commercial use. Installation of Said
Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfi ster.com
• Installation Support
• Care and Warranty Information
13 VALVE FUNCTION
By lifting Lever Handle (13A) up, the valve will be activated allowing water to fl ow. The
water fl ow will increase by continuing to lift up Lever Handle (13A). By rotating Lever
Handle (13A) counterclockwise, the water temperature will decreased to full cold. By
rotating Lever Handle (13A) clockwise, the water temperature will increased to full
hot.
Note: Flush faucet before turning on valve (see step 14).
14 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (14A). Turn Valve (14B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (14A) by
separating the Aerator Shell (14C), Basket (14D), and Washer (14E). Once parts have
been cleaned, reassemble by reversing steps.
15 HOSE REMOVAL
To remove the quick connect attachment: Push up on Quick Connector (15A). Holding
Inner Collet (15B) in place, pull downward on Quick Connector (15A) until Tube (15C)
is free.
16 CARTRIDGE REPLACEMENT & HANDLE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet.
Using a
3 /
32
” Allen wrench, loosen Set Screw (16A) and remove Handle (16B).
Remove Dome Cap (16C) and Retainer Nut (16D) by unscrewing counterclockwise.
Carefully remove Cartridge (16E) by pulling it straight up and out. Inspect and replace
as necessary.
Reassemble faucet by reversing steps.
4
HOT COLD
ON
16A
13A
14A
15A
13A
14B
14E
14D
14C
15B
15C
15A
16B
16C
16D
16E