Pfister GT72-YP2Y - Manual (Page 3)

E
N
G
L
IS
H
ENGLISH
ENGLISH
11
FAUCET FUNCTIONS
7
8
10
9
12
7 CONTROL BODY INSTALLATION
Place Seal Ring (7A) under base of Control Body (7B). From above sink, insert Threaded
Shank (7C) and Flexible Tubing (7D) through other side hole of sink.
8 SECURING CONTROL BODY
From underneath sink, place Round Washer (8A), and Mounting Nut (8B) onto Mounting
Shank (8C). Tighten loosely, make sure Handle (8D) swings equally in both directions.
Tighten Valve Body fi rmly to sink.
9 HOSE ATTACHMENT
From underneath sink, push Connector (9A), located on the end of Hose (9B) fi rmly
upward onto the Inlet Tube (9C), until unable to push any further. Pull down on Connector
(9A). If the housing and the Inner Collet (9D) separate slightly but do not pull off, the
Inlet Tube (9C) connection is secure.
10 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (10A) to Faucet Inlets (10B). Hot water supply line goes
to hot inlet fi tting indicated by red tag (10C). (Supply lines not included). Follow
manufacturer’s instructions when installing supply lines.
11 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
12 SPOUT FUNCTION
Spout (12A) can be rotated around the Faucet Body in any direction.
3
7A
8A
9A
10A
HOT COLD
7B
7C
7D
8B
8C
8D
9B
9C
9D
9A
9C
9A
10A
10B
10B
10C
12A