Pfister GT72-YP2Y - Manual (Page 2)

E
N
G
L
IS
H
ENGLISH
ENGLISH
3
4
2
FAUCET INSTALLATION
5
6
Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING: Read all the instructions completely before proceeding. Price Pfi ster
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• Plumber's putty • PTFE Plumber's Tape • Slotted screwdriver
• Adjustable wrench • Pliers • Flashlight
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4 CHECKING THE CONTENTS OF THE BOX
Upon opening the box, check to ensure that all of the following items are included.
A Spout Body B Control Body C Spout Seal Ring
D Long Nut E Support Washer F Round Washer
G Mounting Nut H Control Body Seal Ring
If any of these items are missing, please contact Price Pfi ster Consumer Service at
1-800-Pfaucet (1-800-732-8238).
5 SPOUT BODY INSTALLATION
Place Seal Ring (5A) under base of Spout Body (5B). From above sink, insert Mounting
Shank (5C) and Inlet Tube (5D) through side hole of sink.
6 SECURING SPOUT BODY
From underneath sink, secure Spout Body (6A) by placing Support Washer (6B) and
threading Long Nut (
7 /
16
Hex.) (6C) onto Mounting Post (6D). Make sure that the bumps
on Metal Washer (6B) are facing up and fi rmly hand tighten Long Nut (6C). Secure
Long Nut (6C) not to exceed a
¼ turn.
Caution: Do not over tighten!
2
A
5A
B
H
C
D
E
F
G
5B
5C
6A
6B
6C
6D
5D