En g l is h english, Faucet installation – Pfister T42-DF0C User Manual

Page 2

ENGLISH

ENGLISH

FAUCET INSTALLATION

Thank you for purchasing this Price Pfi ster product. All Price Pfi ster products are carefully engineered, and factory tested to
provide long trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this product, call 1-800-Pfaucet (1-800-732-8238).

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price Pfi ster

recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE Plumber's Tape

• Plumber's putty

• Slotted screwdriver

• Adjustable wrench

• Pliers

• Flashlight

• Cloth

Your installation may require new supply lines and / or shut-off valves or other additional
tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Spout Body

B Pop-Up Assembly

C Pop-Up Rod

D Long Nut

E Mountingl Washer

F Putty Plate

G Deckplate

H Seal Base

J Spout Base

If any of these items are missing, please contact Price Pfi ster Consumer Service at
1-800-Pfaucet (1-800-732-8238).

5 INSTALLING FAUCET WITH SINGLE HOLE MOUNTING

Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in bottom of Seal Base (5A). Ensure that Seal Base (5A) is pressed onto Spout
Base (5B). Place Spout Base (5B) and Seal Base (5A) onto the bottom of Faucet Body
(5C). From above sink, insert Faucet Supply Tubes (5D) through Hole (5E) on sink.

6 INSTALLING FAUCET WITH DECKPLATE

Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in bottom of Putty Plate (6A). Ensure that the Plastic Putty Plate (6A) is pressed
on the Deckplate (6B). Assemble Deckplate (6B) and Putty Plate (6A) to Faucet Body
(6C). From above sink, insert Faucet Supply Tubes (6D) through Hole (6E) on sink.

BOTTOM GROOVE