Pfister 8T5-CS1C - Manual (Page 7)

7
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use
of other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!
13 FLOW CONTROL FUNCTION (Fig.K)
By rotating Lever Handle (1) slightly clockwise, the valve
will be activated allowing water to flow. The water flow
will increase by continuing to rotate Lever Handle (1) in a
clockwise direction.
14 SHOWER ARM AND SHOWER HEAD
INSTALLATION (Fig.L)
For shower only products: Insert the end of Shower Arm (1)
through the Shower Flange (2). Apply PTFE plumber's tape
to both ends of Shower Arm (1) according to manufacturer's
instructions. Screw the long end of Shower Arm (1) into pipe
(3) elbow inside the wall. Slide Shower Flange (2) tight to
the wall. Screw the shower head (4) to the Shower Arm (1),
placing the Washer (5) in between.
15 SPOUT INSTALLATION (Fig.M)
For tub only products: Screw Spout (1) to Pipe Nipple (2)
and tighten until Spout (1) is properly positioned to the
finished wall.
16 UNIT START UP
Turn on hot and cold water supplies, and check all
connections for leaks.
17 CLEANING THE AERATOR (Fig.N)
For tub only products. It is advisable to periodically clean
the aerator, in order to avoid build-up of dirt and limestone,
which in time could gradually limit the water flow. To clean
the Aerator, disassemble Aerator Housing by separating
the Aerator Head (3), Basket (2) and Washer (1). Once
parts have been cleaned, reassemble by reversing steps.
1
OFF
OPEN
K
4
5
2
1
3
L
1
2
M
N
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where
you purchased your faucet.
2. When replacement parts are not available, please write or
call Price Pfister Consumer Service.
3. Always turn off water and relieve pressure before
working on your faucet.