Pfister 8P8-CT1C - Manual (Page 5)

5
from the Valve Body before soldering. Use copper pipe
adapters (not furnished) in this type of installation.
6 PLASTERGAURD REMOVAL (Fig.D)
Remove Screws (1), and Plasterguard (2) from Valve
Body .
7 VALVE FLANGE ATTACHMENT (Fig.E)
Position trim flange (1) onto the valve body (2) and slide
flush to finished wall. Insert Ring (3) as shown.
8 HANDLE ATTACHMENT (Fig.F)
Place the Lever (1) onto Valve Stem (2) and secure with Set
Screw (3). Install Decorative Cap (4). To remove handle,
reverse steps.
9 VALVE FUNCTION (Fig.G)
By lifting the Lever Handle (1) up, the valve will be activated
allowing water to flow. The water flow will increase by
continuing to lift up the Lever Handle (1). By rotating the
Lever Handle counter-clockwise, the water temperature will
decrease to cold flow only. By rotating the Lever Handle
clockwise, the water temperature will increased to hot flow
only.
Press Diverter Button (2) to divert water from tub to
shower.
4
6
8
9
5
7
C
2
1
D
2
3
1
4
1
2
HOT
COLD
OPEN
2
3
1
E
F
G