Pfister 8E8-CT1C - Manual (Page 6)

6
H
2
7
1
3
5
6
4
J
2
1
3
12 HAND HELD SHOWER ASSEMBLY (Fig.H)
Be sure that rubber washers (1 & 2) are inserted into the
adaper piece (4) and inlet fitting (3). Connect Hose Mount
on to (7) Flexible Hose (5).*Thread inlet fitting (3) onto
bottom of faucet as shown. Thread Shower Arm (6) into
Hose Mount (7).
13 CARTRIDGE REMOVAL (Fig.J)
Turn off water supplies and relieve pressure before
working on your faucet! Loosen Set Screw (1) and
remove Handle (2). Remove the Dome Cap (3) by
unscrewing counterclockwise. Carefully remove the
Cartridge (4) by pulling it straight up and out. Reassemble
by reversing steps.
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where
you purchased your faucet.
2. When replacement parts are not available, please write or
call Price Pfister Consumer Service.
3. Always turn off water and relieve pressure before
working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use
of other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!