beautypg.com

English – Pfister 8E8-CT1C User Manual

Page 4

background image

4

Thank you for purchasing this Price Pfister product. All Price

Pfister products are carefully engineered, and factory tested

to provide long trouble-free use under normal conditions.

This product is easy to install using basic tools and our easy

to follow illustrated instructions. If you have any questions

regarding this product, see info on previous page
1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before

proceeding. Price Pfister recommends calling a professional

if you are uncertain about installing this product!
This product should be installed in accordance with all local

and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply

valves. These are usually found under the basin or near

the water meter. If you are replacing an existing faucet,

remove the old faucet from the basin and clean the basin

surface thoroughly.
3 ASSEMBLY INSTRUCTIONS

If operating pressures exceed 5 BAR (~75 PSI), the use

of a pressure reducer is recommended. Before proceeding

with the assembling, we advise to clean the hot and cold

water tubes, in order to avoid build-up of dirt that could

compromise the functioning of the faucet.

4 WIDTH DIMENSIONS (Fig.A)

The Eccentric S-Adapter (1) will accommodate a range

of width dimensions (2) from 5 1/4” to 6 1/2” [133mm

to 165mm]. S-Adapter center line (3) must be 5 7/8”

[149mm].
5 S-ADAPTER INSTALLATION (Fig.A)

Apply plumber’s tape to all external threads according to

manufacturer’s instructions. Hand tighten the S-Adapters

(1) to inlet pipes (4) projecting through the wall.

Supply

Suggested

Maximum

Minimum

Hot Water

Temperature

65 Cº (150ºF)

80 Cº (175ºF)

15 Cº (60ºF)

Operating

Pressure

3 BAR (44PSI)

5 BAR (73PSI)

0.5 BAR (7PSI)

6 FAUCET ASSEMBLY (Fig.B)

Insert Washers (5) and Bath Mixer Seat (6) into Union Nuts

(8). Insert Wall Cap (7) to S-Adapter (9).
7 FAUCET INSTALLATION (Fig.C)

Wrench tighten Union Nuts (1) to S-Adapters (2). Adjust

Wall Cap (3) so that it sits flush with the finished wall.

C

1

2

3

ENGLISH

HOT

COLD

2

3

1

4

A

5

9

6

8

7

B

This manual is related to the following products: