English – Pfister 040-CNFC/040-CNFCA User Manual

Page 4

Thank you for purchasing this Price Pfister product. All Price

Pfister products are carefully engineered, and factory tested

to provide long trouble-free use under normal conditions.

This product is easy to install using basic tools and our easy

to follow illustrated instructions. If you have any questions

regarding this product, see info on previous page.
1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before

proceeding. Price Pfister recommends calling a professional

if you are uncertain about installing this product!
This product should be installed in accordance with all local

and state plumbing and building codes.
2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply

valves. These are usually found under the sink or near the

water meter. If you are replacing an existing faucet, remove

the old faucet from the sink and clean the sink surface

thoroughly.
3 ASSEMBLY INSTRUCTIONS

If operating pressures exceed 5 BAR (75 PSI), the use of

a pressure reducer is recommended. Before proceeding

with the assembling, we advise to clean the hot and cold

water tubes, in order to avoid build-up of dirt that could

compromise the functioning of the faucet.

4 INSTALLING FAUCET (Fig.A)

Ensure that Seal Base (1) is pressed onto Spout Base (2).

Place Spout Base (2) and Seal Base (1) onto the bottom

of Faucet Body (3). From above sink, insert Faucet Supply

Tubes (4) and Threaded Shank (5) through Hole on the sink.

From underneath sink, secure Faucet Body (3) by placing

Rubber Washer (6), Metal Washer (7) and threading Nut

(8) onto Threaded Shank (5). For thin decks use Flange (9)

instead of Washers (6 & 7) to secure Faucet.

Caution: Do not over tighten!
5 DRAIN BODY INSTALLATION (Fig.B)

The Flange (1) can be installed with or without Rubber Seal

(2). If Drain Flange (1) is installed without Rubber Seal, Apply

a small bead of plumber’s putty underneath the Drain Flange

(1) and around Drain Opening (3). Insert Drain Flange (1) into

Drain Opening. From underneath, slide Rubber Washer (4)

and Metal Washer (5) onto the bottom of Drain Flange (1).

Thread Locknut (6) until Rubber Washer (4) seats securely

inside Drain Opening (3). Remove excess plumber’s putty.

Drop Stopper (7) into Flange (1). Place both Washer (8)

and Drain Tube (9) underneath Locknut (6) and secure by

tightening Nut (10).

Note: Washer (8), Drain Tube (9), and Nut (10) are offered

for North American applications.

Supply

Suggested

Maximum

Minimum

Hot Water

Temperature

65 Cº (150ºF)

80 Cº (175ºF)

15 Cº (60ºF)

Operating

Pressure

3 BAR (44PSI)

5 BAR (73PSI)

0.5 BAR (7PSI)

7
8

ENGLISH