English, Installation steps – Pfister 8P5-DY00 User Manual

Page 2

ENGLISH

ENGLISH

Thank you for purchasing this Price Pfister product. All Price Pfister products are carefully engineered, and factory tested to provide long

trouble-free use under normal conditions. This product is easy to install using basic tools and our easy to follow illustrated instructions. If you

have any questions regarding your product installation call 1-800-Pfaucet (1-800-732-8238)

1 BEFORE PROCEEDING

WARNING: Read all the instructions completely before proceeding. Price

Pfister recommends calling a professional if you are uncertain about installing

this product!

This product should be installed in accordance with all local and state plumbing

and building codes.

WARNING: This product has been designed for use with the Price Pfister

0X8 series pressure balancing valve. It will not work with any other product.

Please review the 0X8 valve installation instructions before installing this

product.

2 SHUT OFF WATER SUPPLY

Locate water supply inlets and shut off the water supply valves. These are

usually found near the water meter. If you are replacing an existing unit, remove

the old unit and clean the mounting surface thoroughly.

3 TOOLS RECOMMENDED

• PTFE plumber's tape or thread sealant

• Philips head screwdriver

• Adjustable wrench • Pipe wrench

• Flashlight

• Cloth

Your installation will require a pipe nipple for the spout installation as well as

other additional tools.

4 CHECKING THE CONTENTS OF THE BOX

Upon opening the box, check to ensure that all of the following items are included.

A Trim Flange with Gasket

B Washer

C Retainer Sleeve

D Extension Stem

E Handle

F Set Screw

G Hex Wrench

H Shower Arm

J Shower Head

K Shower Flange

If any of these items are missing, please contact Price Pfister Consumer Service

at 1-800-Pfaucet (1-800-732-8238).

5 WORK AREA INSPECTION

Verify that the hole sizes and positions in the wall are correct.

6 PLASTERGUARD OPTIONS

A. For installation using plasterguard, knock out Center Section (6B) from Plasterguard

(6A). The use of plasteguard is optional for standard installations.

B. For installation without plasterguard, remove Screws (6C), and

Plasterguard (6A).

INSTALLATION STEPS

8” Min.

30”

Shower Only

48”

Shower Only

” Dia.

4” Dia. for Thin

Wall Installation

” Dia.