English – Pfister F-026-4TWS User Manual

Page 3

ENGLISH

ENGLISH

7 CONTROL BODY INSTALLATION
Apply plumber’s putty into groove on bottom of Gasket (7A) per manufacturer’s
recommendations. Place Gasket (7A) under base of Control Body (7B). From
above sink, insert Threaded Shank (7C) and Flexible Tubing (7D) through side
hole of sink.

8 SECURING CONTROL BODY
From underneath sink, place Washer (8A), and Locknut (8B) onto Mounting
Shank (8C). Make sure Handle (8D) is facing forward and it swings equally in
both directions. Tighten Locknut (8B) ﬁrmly to Shank (8C).

Caution: Do not over tighten!

9 HOSE GUIDE & SOAP DISPENSER GUIDE INSTALLATION
Insert Hose Guide Shank (9A) through Flange Gasket (9B) and insert Soap
Dispenser Guide Shank (9C) through Foam Gasket (9D) and into the sink holes.
(Both Hose Guide and Soap Dispenser Guide can be placed in either hole).

10 SECURING HOSE GUIDE & SOAP DISPENSER GUIDE
From underneath sink, secure Hose Guide (10A) and Soap Dispenser Guide
(10B) by screwing Plastic Locknuts (10C) and (10D). Thread on Bottle (10E)
to Soap Dispenser Shank (10F). Hand tighten.

Caution: do not over tighten!

10A

10C

10B

10D

10E

10F