Pfister GT34-4PS0 - Manual (Page 5)

ENGLISH
ENGLISH
18
14 16
17
15
14 FAUCET PREPARATION
From underneath faucet, remove Nut (14A) from Mounting Post (14B). Remove Putty
Plate (14C) and Deck Plate (14D) from Faucet Body (14F). Assemble Mounting Ring
(14E) and Putty Ring (14G) to Faucet Body (14F). Secure by placing and threading Nut
(14A) onto Mounting Post (14B).
15 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in Putty Ring (15A). Insert the faucet Supply Tubes (15B) through the center
hole of the sink.
16 SECURING FAUCET TO DECK
Remove any excess putty from around the outside edge of Mounting Ring (16A). From
underneath sink, secure the faucet by placing the Metal Washer (16B) and the Long
Nut (
7 / 16 Hex.) (16C) onto the Mounting Post (16D). Make sure that the bumps on the
Metal Washer (16B) are facing up. Tighten until the faucet is firmly connected to the
sink. Do not over tighten!
17 WATER SUPPLY LINES
Gently separate hot and cold Supply Tubes (17A), approximately three inches apart.
Connect water Supply Lines (17C) to Faucet Inlets (17B). Hot water supply line goes to hot
inlet fitting indicated by red tag (17D). (Supply lines not included). Follow manufacturer’s
instructions when installing supply lines. Do not twist Supply Tubes (
17A)!
18 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
Note: After installation is complete, flush faucet (see step 22).
5
17A 17A
16A
16D
16B
16C 14A
14B
14C
14D
14F
14F
14A
14B 14E
14G
15A
15B
17C
17C
17D
17B
17B
HOT
COLD