Pfister GT34-4PS0 - Manual (Page 4)

ENGLISH
ENGLISH
10
11
12
13
STOP Go To Step 17
STOP Go To Step 17
10 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (10A) through Hose Guide (10C). From underneath sink, push
Quick Connect Housing (10B), located on the end of the Spray Hose (10A), firmly upward
onto the receiving Tube (10D), until unable to push any further. Pull down on the quick
connect housing (10B). If the housing and the Inner Collet (10E) separate slightly, but
does not pull off the receiving Tube (10D), quick connect is secure.
11 FAUCET INSTALLATION
Following manufacturer’s recommendations on use, apply plumber’s putty into putty
groove in Deck Plate (11A). Insert Hose Guide (11B) into Hose Guide Flange (11C) and
onto the sink hole. Insert the faucet Supply Tubes (11D) through the center hole of the
sink. Insert faucet Shanks (11E) through the end holes of the sink.
12 SECURING FAUCET TO DECK
From underneath sink, hand tighten Wing Nuts (12A) to Mounting Posts (12B), secure
Hose Guide (12C) by screwing Plastic Locknuts (12D). Hand tighten. Remove any
excess putty from around the outside edge of Deck Plate (12E). Secure the faucet by
placing the Metal Washer (12F) and the Long Nut (
7 /
16
Hex.) (12G) onto the Mounting Post
(12H). Make sure that the bumps on the Metal Washer (12F) are facing up. Tighten until
the faucet is firmly connected to the sink. Do not over tighten!
13 SIDE SPRAY INSTALLATION
Insert Side Spray Hose (13A) through Hose Guide (13C). From underneath sink, push
Quick Connect Housing (13B), located on the end of the Spray Hose (13A), firmly upward
onto the receiving Tube (13D), until unable to push any further. Pull down on the quick
connect housing (13B). If the housing and the Inner Collet (13E) separate slightly, but
do not pull off the receiving Tube (13D), quick connect is secure.
4
10B
10B
10B
10D
10C
10E
10D
10A
11A
11E
11E
11C
11B
11D
12A
12A 12B
12C
12D
12B
12E
12F
12G
12H
13B
13B
13B
13C
13E
13D
13D
13A