Pfister GT529-MDS - Manual (Page 4)

ENGLISH
ENGLISH
12 14
13
15
16
12 PULL-OUT HOSE ATTACHMENT
From underneath sink, push Quick Connector (12A), located on the end of the Pull-Out
Hose (12B) firmly upward onto the Receiving Tube (12C), until unable to push any
further. Pull down on the Quick Connector (12A). If the housing and the Inner Collet
(12D) separate slightly but do not pull off the Receiving Tube (12C), quick connect is
secure.
13 SOAP DISPENSER INSTALLATION
From above sink, insert threaded Shank (13A) of soap dispenser body through Foam
Gasket (13B) and sink hole. From below sink, tighten Nut (13C) and thread on Soap
Bottle (13D) to Shank (13A).
14 SOAP DISPENSER HEAD INSTALLATION
Pour liquid soap (not included) into the Soap Dispenser Body (14A). Insert Pump
Mechanism (14B) into Soap Dispenser Body (14A). Install Dispenser Head (14C) by
pushing firmly onto Pump Mechanism (14B).
15 WATER SUPPLY CONNECTIONS
Gently separate hot and cold Faucet Inlets (15B), approximately three inches apart.
Connect water Supply Lines (15A) to Faucet Inlets (15B). Hot water supply line goes
to hot inlet fitting indicated by red tag (15C). (Supply lines not included). Follow
manufacturer’s instructions when installing supply lines.
16 SECURING INLET LINES
Do not cross Pull-Out Hose Connection (16A) with Inlet Supply Tubes (16B) to avoid
binding, jamming and interference with the movement of the Pull-Out Hose (16A).
4
16A
15A
12C
13A
12A
12B
12C
12A
12D
12A
13B
13C
13D
14A
14B
14C
15A
15B
15C 15B
HOT
COLD
16B
16B