Pfister GT529-MDS - Manual (Page 3)

ENGLISH
ENGLISH
10
11
9
8
2 HOLE INSTALLATION
8 INSTALLING MOUNTING RING
Place Mounting Ring (8A) over Plastic Seal (8B) and sink hole. Align Mounting Ring
(8A) to the center of sink hole. Place a bead of plumber’s putty in the bottom groove
along the outer edge of Plastic Ring (8B).
9 BODY INSTALLATION
Retract Pull-Out Hose ( 9A) up through Faucet Body (9B), until the pullout hose fitting
is flush with the bottom of Mounting Shank ( 9C). Insert Faucet Supply Tubes (9D) and
Receiving Tube ( 9E) through the hole in Deckplate (9F) or Mounting Ring (9G). Handle
(9H) can be oriented to the right or the left.
Note: Do not feed the Pull-Out Hose (9A) back down through the spout yet.
10 SECURING SPOUT BODY
From underneath sink, place Washer (10A) and Locknut (10B) over Pull-Out Hose (10C)
and Supply Tubes (10D). Thread loosely onto Mounting Shank (10E). Make sure that
Handle (10F) is properly aligned to sink. Tighten faucet firmly to sink.
11 QUICK CONNECT & WEIGHT ATTACHMENT
Insert the end of the Pull-Out Hose (11A) into the Weight (11B). Screw Quick Connector
(11C) to the free end of Pull-Out Hose (11A).
3
10A
11A
8A
8B
9A
9B
9C
9E
9A
9F
9G
9B
10B
10D
10C
10E
11B
11C
10F
9H
9D