En g l is h english – Pfister GT529-TMS User Manual

Page 6

ENGLISH

ENGLISH

CAUTION: Maintenance

DISASSEMBLY

1. Replacement parts may be available at the store where you purchased

your faucet.

2. When replacement parts are not available, please write or call Price

Pfi ster Consumer Service.

3. Always turn off water and relieve pressure before working on your

faucet.

NOTE: Trim Care

Cleaning Instructions:
For all Handles and decorative fi nishes, use only a soft damp
cloth to clean and shine. Use of polish, detergents, abrasive
cleaners, organic solvents or acid may cause damage. Use of
other than a soft damp cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar
substance are not acceptable for public areas or Commercial
use. Installation of Said Trim is at Users Risk!

1–800–PFAUCET (1–800–732–8238)

For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfi ster.com

• Installation Support
• Care and Warranty Information

24 FLUSHING

Lift the Valve Lever Handle (24A) up to the full on position. Run water for one minute.

Repeat in hot and cold positions. Reassemble the Spray Head (24B) to the Pull-Out

Hose (24C) by turning Spray Head (24B) clockwise.

Caution: do not over tighten spray head and pull-out hose.

25 AERATOR CLEANING

Over time, the aerator in your faucet may become clogged with debris. To clean the

aerator, unscrew Aerator Housing (25A) from Spray Head (25B). Remove Aerator Seal

(25C) and Aerator Cartridge (25D) from Aerator Housing (25A). Clean Aerator Cartridge
(25D) and Aerator Housing (25A). Reassemble faucet by reversing steps.

26 PULL-OUT HOSE REMOVAL

To remove the quick connect attachment: Push up on Quick Connector (26A). Holding
grey Plastic Colette (26B) in place, pull downward on Quick Connector (26A) until Tube
(26C) is free.

27 CARTRIDGE REPLACEMENT

Turn off water supplies and relieve pressure before working on your faucet.
Carefully unscrew Handle Button (27A). Using a

” Hex wrench, loosen Set Screw

(27B) and remove Handle (27C). Using a Phillips head screwdriver, remove Retaining
Screw (27D) by carefully prying off Dome Cap (27E). Unscrew Retainer Nut (27F), and
carefully remove Cartridge (27G) by pulling it out.
Reassemble faucet by reversing steps.

24C

27A

25A

26A

24B

24A

25D

25C

25B

26B

26C

26A

27B

27C

27D

27E

27F

27G