Pfister GT72-YP2K - Manual (Page 4)

ENGLISH
ENGLISH
MAINTENANCE & CARE
13
15
14
FAUCET FUNCTIONS
12
CAUTION: Maintenance
DISASSEMBLY
1. Replacement parts may be available at the store where you purchased your faucet.
2. When replacement parts are not available, please write or call Price Pfister Consumer
Service.
3. Always turn off water and relieve pressure before working on your faucet.
NOTE: Trim Care
Cleaning Instructions:
For all Handles and decorative finishes, use only a soft damp cloth to
clean and shine. Use of polish, detergents, abrasive cleaners, organic
solvents or acid may cause damage. Use of other than a soft damp
cloth will nullify our warranty!
Special Trim:
Trim products which contain Porcelain or other similar substance are
not acceptable for public areas or Commercial use. Installation of Said
Trim is at Users Risk!
1–800–PFAUCET (1–800–732–8238)
For Toll-Free Pfaucet information call
1–800–PFAUCET (1–800–732–8238)
or visit www.pricepfister.com
• Installation Support
• Care and Warranty Information
13 VALVE FUNCTION
By lifting Lever Handle (13A) up, the valve will be activated allowing water to flow. The
water flow will increase by continuing to lift up Lever Handle (13A). By rotating Lever
Handle (13A) counterclockwise, the water temperature will decreased to full cold. By
rotating Lever Handle (13A) clockwise, the water temperature will increased to full
hot.
Note: Flush faucet before turning on valve (see step 14).
14 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (14A). Turn Valve (14B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (14A) by
separating the Aerator Shell (14C), Basket (14D), and Washer (14E). Once parts have
been cleaned, reassemble by reversing steps.
15 CARTRIDGE REPLACEMENT & HANDLE REMOVAL
Turn off water supplies and relieve pressure before working on your faucet.
Using a
3 / 32 ” Allen wrench, loosen Set Screw (15A) and remove Handle (15B). Remove
Dome Cap (15C) and Retainer Nut (15D) by unscrewing counterclockwise. Carefully remove
Cartridge (15E) by pulling it straight up and out. Inspect and replace as necessary.
Reassemble faucet by reversing steps.
12 SPOUT FUNCTION
Spout (12A) can be rotated around the Faucet Body in any direction.
4
HOT COLD
ON
15A
13A
14A
13A
14B
14E
14D
14C
15B
15C
15D
15E
12A