beautypg.com

Audiovox Prestige APS-2K4 User Manual

Page 5

background image

BATTERY REPLACEMENT:

The transmitter incorporates a small LED visible through the case which
is used to indicate battery condition. You will notice a decrease in
transmitter range as the battery condition deteriorates.
To replace the battery:
1) Remove the small # 0 phillips head screw from the rear of the case.
2) Remove the rear cover to access the discharged battery paying

attention to the proper polarity orientation.

3) Carefully remove and properly dispose of the discharged battery.
4) Insert the new battery, close the case, then reinstall the small case

screw removed in step 1.

5) If you accidently dislodge the circuit board from the transmitter

housing, be certain that the rubber
membrane is seated properly, and
the buttons are properly exposed
from the front view of the case, then
insert the circuit board, and return
to step #4.

QUICK REFERENCE CHART:

You can program any individual channel without reprogramming all
channels. To go directly to a particular receiver channel follow the
chart below:

CHANNEL

1 Ign. On Then
2 Ign. On Then
3 Ign. On Then
4 Ign. On Then
5 Ign. On Then
6 Ign. On Then

VALET SWITCH

Press and Release 3 Times
Press and Release 4 Times
Press and Release 5 Times
Press and Release 6 Times
Press and Release 7 Times
Press and Release 8 Times

LED

1 Flash

2 Flashes
3 Flashes
4 Flashes
5 Flashes
6 Flashes

reprogrammed. Any other transmitter stored in the unit’s memory still
remain operational. If the button is released and not pressed again within
the 5 second period, no change in programming has been made to the
receiver channel. The programmer can move onto a different channel or
erase the transmitter codes as described in 1 above.

5