Acer ISDN P10 - Manual (Page 25)

Chapter 2 — Installation
21
2.4 AcerISDN P10 Utility Installation
To install the utility programs, please follow the instructions listed
below.
1. Insert the AcerISDN P10 Utility Installation Diskette or
CD into drive A: (B:, or D:, etc.).
2. On the task bar, press “Start” and then click “Run”. The
Program Run dialog box will open.
F IGURE 2-17: I NSTALLING THE U TILITY P ROGRAMS
Type “D:\UTILITY\SETUP” in the Run Dialog Box.
Press “OK”. The InstallShield Wizard will load the
AcerISDN P10 utility installation program.
Press “Next>” to begin installing the AcerISDN P10
Utility. Follow the instructions on the screen to complete
the installation.
The next section describes how to use the diagnostic program to
check the card configuration.