Rapid-Air PALLET MASTER (PMDH): PMDH35 & PMDH50. 115VAC, 1PH, 60HZ User Manual
Page 9
9
8. LOOP ARM/EXTERNAL SWITCH
This switch selects either dancer arm (internal) by displaying “LV” for loop arm vertical reel or
“LH” for loop arm horizontal reel (PMD) or external loop control by displaying “RT” for the
RTB and ”RS” for the RS_1. The RLL will work on the “RT” selection.
The external connection for a remote loop control on the PMDH usually isn’t used as there is
not much of a loop to look at for adjusting the motor speed.
9. RESET BUTTONS
A. 15 amp - This is the main circuit breaker for the reel.
10. REMOTE INTERFACE PORT “D” CONNECTOR
This connector is used to communicate with external loop control equipment if used.
CAUTION: Never plug any type of computer or non Rapid-Air equipment into
this plug or severe damage will result. Always consult with the factory when in-
stalling new external controls for compatibility and wiring information.
ELECTRICAL COMPONENT DESCRIPTION
69100804 board - main reel control board
69100014 (RAMM) - D.C. motor board
69100218 dancer arm potentiometer
69100578 circuit breaker
69100315 rocker switch