Qualcraft Armadillo - Manual (Page 13)

Installation and Use
G
ua
rd
ia
n
Fa
ll
Pr
ot
ec
tio
n
6
30
5
S.
2
31
st
S
t.
, K
en
t,
W
A
9
80
32
p
ho
ne
: (
80
0)
4
66
-6
38
5
f
ax
: (
80
0)
6
70
-7
89
2
w
w
w
.g
ua
rd
ia
nf
al
l.c
om
11
Prior to installation, plan your system:
1. All PFAS equipment must be selected and deemed compatible with Armadillo by a Competent
Person.
2. Eliminate or minimize all risk of swing fall hazards.
3. Ensure installation location and work surface are free of all damage, including, but not limited
to, corrosion, rot, rust ,debris, and sharp or abrasive edges and surfaces.
4. All 4 Casters must remain in contact with roof surface at all times.
Installation:
1. Remove Locking Bar and Hitch Pin assemblies.
2. Insert SRL into Armadillo Body. SRL attachment point must face in same direction as
Triple-Locking Carabiner.
3. Insert Large Locking Bar though Armadillo Body installation location and SRL attachment
point, and secure with corresponding Hitch Pin.
4. Insert Small Locking Bar through Armadillo Body installation location and over SRL body, and
secure with corresponding Hitch Pin.
5. Ensure SRL is fully secured into Armadillo Body, and that no possibility exists for accidental
detachment.
Large Locking
Bar secured
over SRL body
Hitch Pins
secured through
Locking Bars
Small Locking Bar
secured through SRL
attachment point
Locking Bars secured
to Armadillo SRL Carriage
with wire and rivet assemblies