Qualcraft ULTRA-Jack Work Bench - Manual (Page 3)

between brace arms is 32” thus enabling installation on studs 16”
on center. 2) Additional poles should be spaced based on the type
and style walk plank used. Additional poles should be installed in
the same manner as the fist pole.
To pass an Ultra-Jack Brace: 1) When passing an Ultra-Jack
Brace that is already installed, an extra brace should be installed
approximately 4 feet above the one to be passed until the original
brace is re-installed. 2) After installing the temporary brace, loosen
the wing nut and allow the brace to be passed to swing clear of
the pole. Do not remove from wall. After brace has been passed
reconnect it to pole and remove the extra brace.
Care and use of the Ultra-Jack Scaffold System: 1) Prior to use
the user should inspect the installation to insure that the system is
properly set up and is ready for use. 2) An access ladder should be
used to provide safe access to the work platform. 3) Ultra-Jack Scaf-
folding must not be used over 48 feet off the ground. 4) There should
never be more than two people on an Ultra-Jack System between
any two poles. 5) Only one walk plank shall be supported between
any two poles. 6) Additional safet accessories such as guardrails,
mid-rails, toe-boards, fall arrest or harness systems must be used
as required by Local, State and Federal OSHA Regulations.
Customer Support and Ordering Information
781-344-1000 • www.qualcraft.com
© Copyright 2003 • Qual-Craft ® Industries • 1551
ULTRA-JACK
OPTIONS INSTRUCTIONS
ULTRA JACK OPTIONS AND ACCESSORIES
MODELS #2002, @2004, #2008, #2009,
#2006, #2012, #2024, #2013