Qualcraft ULTRA-Jack Work Bench - Manual (Page 2)

ULTRA-JACK
OPTIONS INSTRUCTIONS
The Ultra-Jack Pole Anchor and Pole Base are designed
to provide an appropriate mudsill and should be used in
conjunction with an Ultra-Jack Pole Brace to secure the
bottom of the pole. After determining the location, care
should be taken to insure that the ground is firm and free of
small rocks or other objects. The Ultra-Jack Model #2009
Pole Base should be used when the pole is to be installed
on a paved, concrete or other hard packed surface. When
installing on hard packed surface or pavement create a
mudsill by placing one 1 ft. long 2”x 12” piece of lumber
or equivalent under the Pole Base. The Ultra-Jack Model
#2008 Pole Anchor should be used to secure the base of the
pole to soft surfaces. The Anchor should be driven into the
ground so that the 8”x 8” steel plate is resting completely
on the ground and that the spike has been fully seated.
The end of the Ultra-Jack Pole should be placed over the
connector, the buttons depressed to allow the pole to seat
firmly into the Pole Base or Anchor allowing the buttons to
expand into the corresponding holes in the bottom of the
pole. The presence of rocks or other objects or unleveled
ground conditions could prevent the anchor or base from
being fully seated onto the ground. Soft or muddy surface
areas my cause the pole to be unstable and could constitute
an unsafe condition. Always inspect the entire systems
installation prior to use to insure all components have
been installed in accordance with instructions and that the
systems installation is in compliance with Local, State and
Federal OSHA regulations.
Instructions for the use of the Ultra-Jack
Model #2008 Pole Anchor
Model #2009 Pole Base:
Installation of the Ultra-Jack Pole Brace: 1) Position the
pole along the work wall. Use a Qual-Craft Pole Anchor or
Rubberized Base Plate at the bottom of the pole. Place pole
on firm level ground. Do not use on unstable base, on top
of other scaffolds or on roof surfaces. Using a Qual-Craft
Ultra-Jack Brace, secure the pole to the work wall at the
bottom and the top of the pole, and in between at 12 ft in-
crements. Poles must be plumb. The rubber surface of the
pole should face out from the work wall. The round bar of
the brace should be fastened to the work wall at right angle
to the pole. The angle bar of the brace should then be fas-
tened to the right or left as desired. Fasten using two 2” or
longer #12 wood screws per fastening plate. Always fasten
to structural member ie: stud, rafter or joist. The spread
INSTRUCTIONS FOR
INSTALLATION AND USE
MODEL #2002
ULTRA-JACK BRACE
Customer Support and Ordering Information
781-344-1000 • www.qualcraft.com
© Copyright 2003 • Qual-Craft ® Industries • 1551
ULTRA JACK OPTIONS AND ACCESSORIES
MODELS #2002, @2004, #2008, #2009,
#2006, #2012, #2024, #2013