Probuilt Professional Lighting Hang-A-Light 400w Metal Halide - Manual (Page 2)

Instructions for Fixture Mounting and Cord Connection:
1. The light fixture with cord is pre‐wired at the factory for 120‐volt operation.
2. Secure fixture in desired location by placing self‐locking hook around eye bolt, chain, cable or
other suitable mount. OVERHEAD HAZARD ‐ MAKE SURE FIXTURE IS SECURE.
3. With lamp, safety cage and bottom guard in place, connect fixture to 120V electrical service using the
power cord supplied. DO NOT CONNECT fixture to power source with safety cage, lamp or bottom
guard missing.
4. Use only 3‐wire extension cords of the appropriate type, length and gauge for the specific
circumstances and make sure all cords and plugs are in good condition.
5. Make sure all electrical connections are secure. Keep cords secure with cable ties or other appropriate
means.
Instructions for Rewiring the Fixture to a Power Supply Other than 120 Volts:
1. The light fixture with cord is pre‐wired at the factory for 120‐volt operation.
2. DISCONNECT FIXTURE FROM POWER SOURCE. Remove the safety cage, lamp and bottom guard.
3. Locate the access plate with two (2) knock‐outs on one side of the fixture housing. Remove the two (2)
screws that hold the access plate to the housing.
4. Disconnect and remove the factory‐supplied power cord. DO NOT USE the power cord at any voltages
other than 120 volts AC.
5. Remove one of the 3/4” knock‐outs in the access plate and route the new incoming power cord (user‐supplied)
through the knock‐out hole.
6. Use a strain‐relief bushing or conduit fitting (user‐supplied) to secure and protect the new power cord.
7. Identify the appropriate lead for the desired electrical service (208V, 240V or 277V) and remove cap from
this lead. Make all necessary connections and cap off any unused leads.
8. Re‐attach the access plate to the housing.
9. Install the safety cage, lamp and bottom guard according to instructions.
10. Mount fixture and connect to appropriate electrical source.
WARNING !
Verify all wiring connections.
Insure that the proper voltage leads on the light fixture have been selected to match the supply voltage.
Improper wiring may damage the transformer and result in fire, personal injury or property damage.
Manufactured by ProBuilt Professional Lighting, LLC ‐ 1170 Allanson Road, Mundelein, IL 60060
Toll Free: 877‐707‐0800 www.wobblelight.com
E
EISA
Compliant
CAUTION
!
• Metal Halide lamps emit ultraviolet (UV) radiation
• Do not stare at exposed lamp while operating
• Possible skin or eye irritation can occur from exposure > 15 minutes
• HOT SURFACES – Do not re‐lamp, move or service fixture until it has cooled.
Product Registration : To receive important product information and updates please follow these steps.
1. Send an e‐mail to [email protected].
2. Post the word “registration”
in the subject field.
3. Include your name, company, address, phone number and type of model purchased.
4. If you prefer to register by phone, please call Wobblelight®
Customer Care at 877‐707‐0800 between
the hours of 8:30 a.m. and 5:00 p.m. (U.S. Central Time).
090929‐Rev.A