beautypg.com

Maintenance – Powermate P-WLE-1639 User Manual

Page 14

background image

Questions? Call Toll Free at 1-800-737-2112

Copyright © 2008 MAT Engine Technologies, LLC

Maintenance

(Continued)

• Save all instructions

Lubrication

B

Add a small amount of engine oil to lubricate parts and pivot points.

Refer to “Periodic Maintenance Schedule Table” for time intervals to lubricate parts.

How to Change the Engine Oil

C

1. Stop the engine and let it cool.
2. Disconnect spark plug wire from the spark plug.
3. Raise the front of the unit, by lowering the height

of the front wheels. Refer to “How to Edge Along a

Curb”.
4. Insert a flat pan under the edger, underneath the oil

drain plug and frame hole.
5. Remove oil dipstick. (See Figure 3)

6. Remove the oil drain bolt and washer.
7. Allow all oil to drain through the frame hole into the pan.

IMPORTANT:

Used oil is a hazardous waste. Place oil in a

sealed container and take to your local recycling center. Do

NOT discard with household waste.

8. Replace and tighten the oil drain plug and washer.
9. To re-fill engine with oil, see engine preparation section

“How to Check Oil and Fill to Proper Level.”

How to Replace the Belt

D

IMPORTANT: Only use a replacement belt from the manufacturer.

To order spare parts call us at 1-800-737-2112.

1. Disconnect the spark plug wire from the spark plug.
2. To ease the replacement of a belt, remove the control rod

(See Figure 2). This will allow the blade arm to rotate

back creating slack in the belt.
3. Remove the two rear guard bolts to remove the engine

pulley cover. (See Figure 11)

NOTE: Refer to Figure 10 when following the steps below:

13

Drain Plug and Washer

Spacer

Engine Pulley

Engine Pulley

Cover

Rear Guard

Bolts

Figure 10

Figure 11

Frame Hole

Pan

This manual is related to the following products: