Northstar Trailers SPORTSTAR II - Manual (Page 10)

ROTATE THE TRAILER TO AN UPRIGHT POSITION.
Position the
trailer so the tires are on the ground. More than one person is required to rotate the
trailer; DO NOT ATTEMPT TO ROTATE THE TRAILER TO THIS POSTION ALONE.
STEP 6: ASSEMBLE AND INSTALL LIGHTS
INSTALL TAIL/BRAKE LIGHTS
a. Fasten the taillight/brake light L-brackets (O) to the frame using two, 1” bolts
(J), one small flat-washer (I) and one small lock-washer (H) for each bolt.
b. Remove the nuts from the back of the taillight (M).
c. Determine the length of the wires needed to connect the wiring harness with
the light, then twist the wires together to shorten the wire slack.
d. Place the loop from the harness’s white ground wire over the closest stud on
the back of the light.
e. Connect the taillight wires with like colors from the wiring harness.
f. Slide the studs on the back of the taillight (M) through the L-bracket.
g. Slide the license plate bracket (P) onto the taillight studs.
h. Use the nuts from the back of the taillight to fasten the light to the bracket.
i. Shove any excess wire back into the eyehole of the frame.
j. Tie off any wiring slack with a small zip-tie.
Note: follow the same sequence for the passenger-side taillight, but without the license
plate bracket.