MoJack ZR - Manual (Page 5)

MoJack ZR Lift MoJack ZR Lift
8 9
Operating Instructions
STEP 3
Operating Instructions
STEP 5
Move mower onto MoJack ZR
The MoJack ZR must be used on a solid level surface.
• Carefully roll or drive mower onto Wheel Pads.
• Place the mower in neutral or disengage hydraulic drive.
• Stop engine and remove the key.
STEP 4
Strapping Front Mower Tires to Wheel Pads
Secure the front mower tires to the Wheel Pads
using the Safety Straps.
• Wrap the safety strap over the mower tire
and secure the hook into the loop on the
wheel pad .
• Tighten the safety straps by pressing down
on the metal clip.
4
Safety Strap 4
2
Wheel Pad 2
Raising the Mower
• Raise the mower by rotating the Crank Handle clockwise.
• See Step 10 for raising the mower with drill attachment.
Do not attempt to lift more than 250 lbs.
front end weight.
The MoJack ZR must be used on
a solid level surface.
The engine must be turned off and
key removed.
The mower must be in neutral or
hydraulic drive disengaged.
The parking brake must be off during this step.
The Safety Straps must be firmly tightened
holding wheels to wheel pads.
STEP 2
Aligning Wheel Pads to Fit Mower
• Place the MoJack ZR wheel pads 6” in front of the
mower’s front tires.
• Remove Push Pins and align the Wheel Pads so that
the front tires will be centered on the Wheel Pads.
• Replace the Push Pins to lock the Wheel Pads to
the Scissor Frame.
Wheel Pads must be equal distance from the
Scissor Frame to maintain proper balance.
NOTE: The MoJack ZR is equipped with a
Shear Pin to protect itself from accidental
overload. If the MoJack ZR is overloaded
with too much weight, the Shear Pin will
break and release the Crank Handle from
the screw and allow the Crank handle to
rotate freely. If this happens, a new
Shear Pin will need to be installed.
Replacement of Brass Shear Pin
• Remove the rubber O-ring retainer.
• Slide out the broken Shear Pin and replace
with new Shear Pin provided with the
MoJack ZR. You may need to use a small
punch or nail to push out the broken
Shear Pin. DO NOT USE A DRILL TO
REMOVE SHEAR PIN.
• Replace the rubber O-ring retainer making
sure it is seated in the groove.
Shear Pin
Shear Pin Hole
Drive Socket
O-Ring Retainer
4