Lincoln Electric IM10154 SAE-300 HE - Manual (Page 8)

A-1 INSTALLATION
SAE-300 ® HE
A-1
TECHNICAL SPECIFICATIONS - SAE-300 ® HE
Make/Model Description Speed (RPM) Displacement Starting Dry
System Capacities
3 Cylinder 91.47 cu. in 12VDC battery Fuel: 16 gal.
24.8 HP(18.5kW) (1.5 ltrs) (Group 24, 650 60.6 L.
KUBOTA Naturally Aspirated High Idle 1800 cold crank amps)
D1503-M Water-Cooled Low Idle 1440 Bore x Stroke 1.4 KW Starter Oil: 5.9 Qtrs.
EPA Diesel Engine Full Load 1800 5.6 L.
Tier 4 Cast Iron Cylinder, 3.27” x 3.64”
Compliant Block/Crankcase (83mm x 92.4mm) Coolant: 7.82 Qts.
7.4 L.
40 A. Alternator
w/ built in reg.
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
MODEL HEIGHT WIDTH DEPTH WEIGHT
K3201-1 45.5 in. (2) 24.3 in. 62.8 in. 1432 lbs.
CSA Without (1156 mm) (616 mm) (1594 mm ) (650 kg.)
Wire Feed Module
K3201-2 45.5 in. (2) 24.3 in. 62.8 in. 1465 lbs.
CSA With (1156 mm) (616 mm) (1594 mm ) (665 kg.)
Wire Feed Module
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT * Duty
VOLTS @ RATED AMPS CYCLE
300 Amp DC Welder 30V @ 250A 100%
All Copper Windings 32V @ 300A 60%
Pure DC Power Generator 90V DC Max. OCV @ 1800RPM
Auxiliary Power (1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 120V
13 Amps @ 240V
PHYSICAL DIMENSIONS (2)
*
Based on a 10 min. period.
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2) Height to top of exhaust elbow.