Lincoln Electric IM10088 SAE-300 - Manual (Page 8)

A-1 INSTALLATION
SAE-300 ®
A-1
TECHNICAL SPECIFICATIONS - SAE-300 ®
Make/Model Description Speed (RPM) Displacement Starting Dry
System Capacities
4 Cylinder 135 cu. in 12VDC battery Fuel: 16 gal.
4 Cycle (2.2 ltrs) (Group 24, 650 60.6 L.
Perkins Naturally Aspirated High Idle 1800 cold crank amps)
404D-22 Water-Cooled Low Idle 1400 Bore x Stroke 2.0 KW Starter Oil: 11.2 Qts.
EPA Diesel Engine Full Load 1725 10.6 L.
Tier 4 interim Cast Iron Cylinder, 3.3” x 3.9”
Compliant Block/Crankcase (84mm x 100mm) Coolant: 9.5 Qts.
32.7HP @1800 RPM 9.0 L.
65 A. Alternator
w/ built in reg.
INPUT - DIESEL ENGINE
RATED OUTPUT @ 104°F(40°C) - WELDER
MODEL HEIGHT WIDTH DEPTH WEIGHT
(K3003-1, K3003-2, 45.5 in. 24.00 in. 65.0 in. 1453 lbs.
K3003-3) (1156 mm) (610 mm) (1651 mm ) (659 kg.)
CSA Without
Wire Feed Module
RATED OUTPUT @ 104°F(40°C) - GENERATOR
DESCRIPTION RATED DC OUTPUT * Duty
VOLTS @ RATED AMPS CYCLE
300 Amp DC Welder 30V @ 250A 100%
All Copper Windings 32V @ 300A 60%
Pure DC Power Generator 98V DC Max. OCV @ 1800RPM
Auxiliary Power (1)
3,000 Watts Continuous, 60 Hz AC
26 Amps @ 115V
13 Amps @ 230V
PHYSICAL DIMENSIONS (2)
*
Based on a 10 min. period.
(1) Output rating in watts is equivalent to volt-amperes at unity power factor. Output voltage is within ± 10% at all loads up to
rated capacity. When welding, available auxiliary power will be reduced.
(2) Height to top of exhaust elbow.