2 installing the cover – Asus 1U Rackmount Chassis Kit R10-A2P4 User Manual

Page 16

Chapter 2: Hardware setup

2-4

2.2.2 Installing the cover

1. Position the cover on top of the chassis with the thumbscrews on the

rear, and leaving a gap of about half an inch from the front panel.

3. Slide the cover toward the front until it snaps in place.

4. Tighten the thumbscrews on the rear to secure the cover.

2. Make sure that the side markings on the cover (two on each side) are

aligned to the grooves on the chassis.

Thumbscrews

Side markings

Grooves