Nilfisk-ALTO 106269015 - Manual (Page 14)

12
NEPTUNE PE/DE
Original Instructions
6 After using the cleaner
6.1 Switching off the
cleaner 1. Close water tap
2. Activate spray handle without
lance in order to empty all
residual water in the system.
3. Turn the ON/OFF switch to
position “OFF”.
4. Turn off the engine.
5. Activate spray handle until
the washer is depressurised.
6. Lock the safety catch on the
spray handle.
6.2 Storing / frost
protection It is advisable to store the ma-
chine in a frost proof place be-
tween operations. If this is not
possible the machine should be
protected in the following way:
1. Disconnect the water inlet
hose. Remove the lance and
empty it of water.
2. Start the machine allowing it
to run with the spray handle
opened until it is empty of
water.
3. Place a suction hose in a
bucket with 6-8 l (1.5-2 gal-
lons) anti-freeze.
4. Place the spray handle (with-
out spray lance) above the
bucket, activate the spray
handle so that the anti-freeze
can circulate.
5. Place the psray handle above
the opening of the anti-freeze
container and allow the ma-
chine to pump all of the solu-
tion back into the anti-freeze
container. The anti-freeze can
be re-used, but keep in mind
that it is slightly diluted with
water each time this is done.
Important:
To avoid damage always ensure
that the washer, the hoses and
the spray lance are unfrozen
before restarting. Place the
washer and the accessories in
a warm environment for some
time before starting up.