AG Neovo TV-01 - Manual (Page 4)

6
Installation
1 Installation of TV tuner function
1.1 Plug the TV antenna or cable TV connection to the “ANT
INPUT” on the rear of the TV Tuner Frame.
1.2 Connect the “VIDEO OUTPUT” port on the rear of the TV
Tuner Frame to the “VIDEO INPUT” port of LCD monitor
by using the video cable included.
1.3 Connect the “AUDIO OUTPUT” port on the rear of the TV
Tuner Frame to the “AUDIO INPUT” of speaker by using
the audio cable included.
1.4 Plug power connection of power adapter into the “DC 9V
IN” port on the rear of the TV Tuner Frame.
2 Installation of remote controller
2.1 Remove the battery cover on the rear of remote controller.
2.2 Insert the batteries included into the slot. Be sure the
direction of battery’s pole is correct.
2.3 Attach the cover back to the remote controller.
3 Setup of TV channels
3.1 Turn on the LCD monitor connected to the TV Tuner
Frame.
3.2 Press the SCAN button on the remote controller to scan all
the available channels automatically.
4 Installation of photograph to the frame
4.1 Remove the photograph inside the frame already. You
may need to shake the TV Tuner Frame up and down.
4.2 The frame is designed for photographs up to 5” by 3” (12.7
by 7.6 cm) size. You may need to refine the size of your
photograph to fit into the frame.
7
4.3 Insert the photograph and be sure it is positioned properly.
The photograph should not cover the remote control receiver
window. Otherwise, the remote controller will be no function.