XLT XD-9006B - Manual (Page 26)

Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
26 HOOD SERVICE PROCEDURES
Complete VFD manual available at www.xltovens.com .
Hitachi X200 Restoring AVI Defaults
Access program parameters by pressing the button one time and using the up and down
arrow buttons to navigate to the appropriate parameter. Press the button again to make
adjustments to that parameter by using the up and down arrows. To store the new settings press the
button one time.
B031 = 01
B084 = 01
Press and hold the and buttons all at the same
time. Release the buttons all at once and the country code should appear in the dis-
play (USA). Hitachi’s factory settings are now restored.
To install AVI Defaults press button one time and enter following parameters
A001 = 01
A003 – USA = 60 Hz.
World = 50 Hz.
A082 = Supply voltage at location 200, 215, or
230 choose appropriate voltage.
A093 = 3000
A094 = 01
A096 = 10
B002 = 25
C001 = 02
C002 = 03
C003 = 04
C004 = 05
C014 = 00
F001 = See Figure 1
H004 = 4
B031 = 03
Put controller into display mode by pressing the button and holding until d001 appears
on the display release and then press the button one time. The display should show
0.0.
Test run the motor by turning on one of the oven/hood switches located on the face of the hood.
Read the entire instruction before programming.
TIP