XLT XD-9007A (ELEC Oven Version – C, AVI Hood Version – C) - Manual (Page 19)

19
Technical Support US: 888-443-2751 Technical Support INTL: 316-943-2751
Temperature Control Programming Procedure
OVEN SERVICE PROCEDURES
SP 260˚C/500˚F
nnn 311/5
AL 315˚C/600˚F
HSA .1
Pb 4.0
ti 5.0
td .00
1P 30
C 2
rL 204˚C/400˚F
rH 310˚C/590˚F
OLH 100
tOL InF
Figure 3
P1 2˚C/10˚F
P2 0
P3 315˚C/600˚F
P4 r
P5 1
P6 H.A.
P7 d
P8 OFF
P9 0
P10 100
P11 311
P12 7
Figure 2
Read the entire instruction before programming.
TIP
Configuration Button Functions
=The new setting of the selected parameter is
stored and the display advances to the next
parameter. This is required between each
parameter.
UP= Increases the setting of the selected parameter.
DOWN=Decrease the setting of the selected parameter.
1. Open V2 switch for Basic Configuration (Figure 1)
 Remove instrument from its case
 Open switch V2
 Re-insert the instrument back in its case
2. Basic Configurations
 Using the configuration buttons, scroll through
parameter codes, changing them to match (Figure 2)
 After P12 _._._._. Will appear
3. Close V2 switch after Basic Configuration (Figure 1)
 Remove instrument from its case
 Close Switch V2
 Re-insert the instrument back in its case
 Error 400 will appear. Press and hold the and
to
clear
 000 will appear
4. Advanced Configurations Procedure
 Scroll through the parameter codes to nnn. Change
nnn to 311 to unlock the advanced configuration
 Using the configuration buttons, scroll through
parameter codes, changing them to match Figure 3
 Scroll through the parameter codes again and
change the nnn to 5. This locks the advanced con-
figuration
 Scroll through the parameter codes again and verify
nnn is ON