WolfVision VZ-15b User Manual - Manual (Page 7)

HOW THE VISUALIZER WORKS
(all Visualizers)
b
a
A light projector (b) inside the WolfVision Visualizer projects the light via a mirror inside the unit and a mirror on the
reflector head onto the working surface. The video camera (a) inside the unit scans the picture where the light falls.
The optics of the camera and the light projector are synchronized. This means that when the size of recording area
is increased or decreased with the ZOOM-keys (#15,#16), the size of the illuminated area on the working surface is
also increased or decreased.
Thus the illuminated area on the working surface always indicates where the camera scans the picture. (In fact, the
scanned area is fractionally smaller than the light field.)
1. Press the release
button
2. Pull arm
upwards
BASIC PREPARATIONS
(all Visualizers)
1. Press the release for the arm (#11) and simultaneously pull the arm upward. Make sure that the arm is extended
to its full length.
2. Connect the power cable to the unit (#36) and plug it in.
3. Connect a control monitor (if required) to the Preview video output (#31 or #43).
4. Connect a large viewing monitor or a projector to one of the outputs of the Visualizer.
For choosing the right output please read page the previous pages!
5. Turn the main power switch (#34, on the back of the unit) to "I". The red power indicator (#29) on the control panel
indicates that power is supplied.
6. Press the POWER on key (#28) on the control panel. The Visualizer now runs the "power-on preset" (=automatic
focusing of an A5 format on the working surface) during which the green LED light (#30) is flashing. As soon as the
green LED light stays illuminated you can start working with the Visualizer.
7