NEWPORT iDRA Controller User Manual
Page 43

39
3.2.10 Analog Output (Retransmission)
This unit is equipped with three physical outputs that can only be configured as
follows:
a) Alarm 1, Alarm 2 & Analog Out
b) Output 1, Alarm 2 & Analog Out
Analog Output is available only if the Analog Output option board is factory
installed.
Figure 3.9 Flow Chart for Analog Output (Retransmission)
ENTER ANALOG OUTPUT MENU:
Press
a
1) Press
a, if necessary, until CNFG prompt appears.
Press
d
2) Display advances to
INPT Input Menu.
Press
a
3) Press
a, if necessary, until Display advances to ANLG
Analog Output Menu.
Press
d
4) Display advances to Analog Output
CURR or VoLT
Current/Voltage Submenu and flashes the previous selection.
CURRENT/VOLTAGE SUBMENU:
Press
d
5) Display flashes
CURR Current or VoLT Voltage.
Press
b
6) Scroll through the available selection: Current or Voltage.
(Example
VoLT).
Press
d
7) Display shows
STRD stored message momentarily and then
advances to
RD1 Submenu only if it was changed, otherwise
press
a to advance to RD1 Reading 1 Submenu.
It
is required that you put the controller in the Standby Mode for any
configuration change other than Set Points & Alarms.