White’s Electronics TDI - Manual (Page 6)

6 PulseScan TDI Owner’s Guide
8. Adjust the elbow cup strap so that it is loose enough for you to slide
your arm in and out without loosening each time you want to set the detector
down. The elbow cup strap provides extra leverage and control. However,
some prefer not to use it.
9. Install battery as described in next section.
0. It should be noted at this point that the detector may not work as expected
indoors due to the high degree of metal used in modern construction. It is best to
tune and practice out-of-doors to ensure stable, predictable results. Additionally,
freshly buried targets will rarely produce the normal depth results of targets that
have been naturally lost and settled in undisturbed ground. Due to the abnor-
mality caused by digging a hole in the ground matrix, and the lack of the normal
target to soil reactions, it may take a number of years for freshly-buried targets to
respond at true depths. The best way to determine true detection depth is in real
search conditions.
. Hip Or Chest Mounting -
a) On top of the control box, the rod-to-case mounting plate has four
Phillips head screws. Remove these four screws and remove the rod/loop/arm
cup assembly from the top of the control box. To prevent moister/dirt from
entering the control box, replace the four screws on top the control box (sink all
the way) without the rod or mounting plate.
b) Adjust/unravel enough loop cable wrapped around the rod, to allow
slack to sweep the rod/loop and connection with the control box. Use two velcro
straps provided to secure loop cable around rod.
c) The control box can be worn on ones chest, hip, or waist based on
personal preference. Belt hook provided on bottom of control box as well as
four “D” rings to attach camera/dog leash connector type straps.