White’s Electronics TDI - Manual (Page 5)

PulseScan TDI Owner’s Guide 5
. Remove all parts from the shipping carton and check assembly page to
make sure all parts are present.
. Install black rubber washers on fiber clevis/lower rod, insert clevis lower rod
onto loop ears. Use only nonmetallic washers, fiber bolt, and fiber thumbnut to
secure loop/search coil to clevis/lower fiber rod.
. Unlock “S” rod cam-lock and insert clevis/lower rod into curved “S” rod so
that stainless steel spring clip buttons line up and lock into one of the adjust-
ment holes in the curved “S” rod. Turn cam-lock to secure. The second or third
adjustment holes are suitable for average sized adults. Individuals six feet or
taller should use fully extended position. Individuals well oversix feet tall should
purchase the optional Tall Man Rod accessory.
4. Unravel loop cable and wind the cable around the clevis and rod assembly,
first revolution over the top of the rod. Wind cable all the way to the top of the
curved “S” rod, about five revolutions. Use the black cable retainers, one near
the loop, and one near the top of the curved “S” rod, to hold the loop cable in
place.
5. Unlock control box rod cam-lock and insert curved “S” rod so that stainless
steel spring clip buttons line up and lock into the rod on top of the control box.
The “S” rod is designed to curve up towards the display. However those who
prefer to sweep the loop close to their feet may desire to assemble the “S” rod to
curve down towards the ground. Turn cam-lock to secure. Plug loop connector
into control box, screw lock ring to secure.
6. Grip the instrument by the handle, with your arm in the elbow cup with strap
and sweep the loop/search coil over the floor. If the instrument fit feels uncom-
fortable, readjust clevis/lower rod length with spring clip button and cam-lock so
that search coil can be held near the floor without requiring stooping over.
7. Remove the protective paper from the two black arm cup foam pads.
Carefully align pads on the inside of the elbow cup, one on each side of the
center rod, and press firmly into place.
ASSEMBLY INSTRUCTIONS -