Autostart AS-1725 SH - Manual (Page 13)

AS-1725 SH Installation Guide P. 13
OPTION 2* Ignition Valet ENABLED
OPTION 3 Ignition Valet ENABLED
MODE 3 * INDICATES DEFAULT SETTING
FUNCTION 1 – Home Valet TM
OPTION 1 Home Valet ENABLED
OPTION 2* Home Valet DISABLED
OPTION 3 Home Valet DISABLED
FUNCTION 2 – AUX 3 / Zone 3 Programming
OPTION 1 1-sec. output when TRUNK button is pressed for 3 sec. with Ignition OFF
or under remote run
OPTION 2* Constant output while the TRUNK button is pressed
OPTION 3 Output with Disarm and Rearm pulses
FUNCTION 3 – AUX 2 Programming
OPTION 1 Constant output while the LOCK and UNLOCK buttons are pressed.
In Safe Start Mode: activate AUX 2 by pressing the START button.
OPTION 2* Toggle ON/OFF (with 30-second timeout)
OPTION 2 Toggle ON/OFF (with 60-second timeout)
OPTION 4 Priority Door Access
FUNCTION 4 – AUX 1 Programming
OPTION 1 Horn Confirmation upon the 2 nd press of the LOCK button.
OPTION 2* Priority Door Access
OPTION 3 Horn Confirmation upon the 1 st press of the LOCK button.
FUNCTION 5 – External Trigger
OPTION 1 Zone 3 rearm (Trunk Pin: a disarm pulse is sent before the Trunk opens,
the vehicle rearms 4 seconds after the Trunk is closed).
OPTION 2* Engine Start/Stop
OPTION 3 Key Sense
OPTION 4 Smart Ignition Re-Lock
Tach Programming
About Tach Programming
If you press the START button before carrying out a Tach Programming procedure, the
Remote Car Starter will make no attempt to start the Engine and the Parking Lights will give
5 flashes.
If order to carry out Tach Programming, you may simply follow the Automatic Tach
Programming procedure.
The Remote Car Starter stores Tach settings regardless of the procedure used at the time
of Tach programming. All Tach settings are cleared when the Remote Car Starter is reset. A
new Tach Programming procedure has to be carried out only if the Remote Car Starter is
reset.
Multi-speed Tach Programming
Tach signals may vary from vehicle to vehicle. The Remote Car Starter is designed to read
a wide range of Tach signals produced by recent Ignition systems. There is no necessary
manual adjustment. Nevertheless, a Tach-programming procedure must be carried out
every time a new Remote Car Starter Unit is installed. This is because the Tach signals