WARN 4700 DC - Manual (Page 9)

PAGE 9 85362 Rev. A0
Winch Installation to a fixed location- continued
To secure the winch, always use:
▫ A flat, secure mounting location at least 3/16 in. (4.8 mm) thick steel.
▫ 3/8 in. lockwasher x 4.
▫ 3/8-16 x 1in. long, hex head capscrew, Grade 5 or better x 4.
▫ Torque mounting bolts to 30-35 ft-lbs (41-47 Nm).
Bolt length may need to be longer that specified above depending upon the thickness of the material the
winch is mounted to.
Wiring Instructions
WARNING
Shock & Fire Hazard
Failure to observe these instructions could lead to severe injury or death .
WARNING !
 Do not route electrical cables
across sharp edges.
To Prevent Serious Injury or
Read and follow all wiring
Death from Electrical Fire:

 Do not route electrical cables
through or near moving parts.
instructions included in
operators manual.
 Insulate and protect all exposed
wiring and electrical terminals.

Never route electrical cables across sharp edges

Never route electrical cables through or near moving parts.

Always read and follow all wiring instructions included in operators guide.

Always insulate and protect all exposed wiring and electrical terminals
 Install battery cables with red lead connected to the positive terminal of battery, and black lead to
the negative terminal of battery.
 Verify that all wiring connections are clean and tight.
Before using the winch, verify the following:
 Wiring to all components is correct.
 There are no exposed wiring or terminals, cover any existing exposures with insulator plate,
terminal boots, heat shrink tubing or electrician’s tape.