Audiovox AA-RS10CS - Manual (Page 10)

Page 10
Feature Selection 1 Flash 2 Flashes Default
First 1 Second Door Locks 3.5 Second Door Locks 1 Second
Second 10 Minute Run Time 15 Minute Run Time 10 Minute
Third Park Lights Steady On Park Lights Flash Steady
Fourth (No Function) Tach Operation Tach
Fifth (No Function) (No Function) ------------
Sixth Ign. 2 Off During Crank Ign. 2 On During Crank Off During Crank
Seventh Diagnostics Off Diagnostics On Off
Eighth (No Function) (No Function) -------------
Ninth Gasoline Engine Diesel Engine Gasoline
Tenth Starter Pole 5X Starter Pole 3X Pole 5X
NOTE:
1) When selecting Diesel operation, (Feature Nine), over gasoline, the only change is to the ignition circuits.
When Diesel is selected, the ignition circuits will power up 10 seconds before the start circuit. The intent of this
feature is to allow the glow plug warming required by some diesel engines. If your vehicle is a instant start diesel,
it is not necessary to activate this feature.
NOTE: When selecting Diesel mode, be certain that the intended vehicle has a true tach reference and be certain to
connect the tach input wire.
2) The difference between selecting Starter Pole 5X or Starter Pole 3X, (Feature Ten), is considering the time it
takes from when the unit reaches the pre-set RPM to when the Starter Motor drops out. This feature allows fine
adjustments when you note a slight overcrank. If after programming tach, the unit seems to hold the starter
engaged slightly longer than necessary, select this feature to pole 3 X. If the unit starts and the starter drops out
properly, (NO OVERCRANK) no change is necessary.
To program these selectable features:
1. Start with the programming switch in the OFF position.
2. Turn the ignition key to the ON position.
3. Flip the program switch ON - OFF - ON - OFF - ON - then OFF.
4. Immediately turn the ignition key OFF, then back to ON.
5. Flip the program switch ON - OFF - ON - then OFF.
6. Use button 1 on the transmitter to advance to the feature that you want to change. EXAMPLE - If you need to change
programmable feature number 3, press and release button 1 on the transmitter 3 times in succession. The parking
lights will flash 3 times confirming that selected feature 3 can now be programmed.
7. Use button 2 on the transmitter to change the selection of the programmable feature. If you are not sure what the setting
for any feature is, press button 2 one time, the parking lights will flash once or twice indicating the features setting.
Note: Once you enter the feature programming mode, do not allow more that 15 seconds to pass between steps, or the
programming will be terminated.
2. Programming Tach Rate:
NOTE: All applications require that tach be programmed.
NOTE: All applications require that tach be programmed.
The unit will not operate unless tach is programmed. If an attempt is made to start the vehicle via the remote start without
first programming tach, the unit will flash the parking lights 7 times indicating tach has not been learned and stored. If the
tach rate is not properly programmed to the specific vehicle, the unit may not realize that the vehicle is running in certain
instances reengage the starter motor.
The AA-RS10CS Remote Car Starter will learn the tach rate of most vehicle's single ignition coils, multiple coil packs,