Audiovox PLV16081 - Manual (Page 11)

E
10
2-3 Xxxxxxx Xxxx
AUDIO 1/1(L+R) FTA
2007/01/31 07:38 07:00-08:00 TV LEVEL: Good
Xxxx xx xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
xxxxxx xx xxxx xx xxxxxxxx x xxxx xxxxx xxx xx xxx
xxxxxxxxxxx xx xxxx xxxxx xx x xxxxx xxx xxxxxx x xxxxxx xxx
Position no.
Time information
Audio
information
ATSC data information
(only ATSC)
Signal
strength
(only ATSC)
Rating
information
ATSC data
information
(only ATSC)
USING THE TV
Connect an antenna or CATV cable or Satellite system to the TV antenna terminal
before searching TV channels.
Searching for TV channels automatically
(Only appears to the first time Power ON)
When this unit is connected to an antenna, or a CATV cable or
satellite system, it can automatically search for channels with
adequate signal strength.
Watching television
Viewing a television station after the auto/manual search for channels.
1. Press the FUNCTION button to TV mode.
2. Press the CH+ or CH- button to select a channel, or press the number button on the remote to
select the channel you want to watch.
• For channels 1 to 9, enter one-digit channel number.
• For channels 10 to 99, enter two-digit channel number.
• For channels 100 or over, enter three-digit channel number.
NOTE
• When a channel is selected, the channel number is displayed on the top right corner of the screen.
This number will disappear after a few seconds.
1. Connect the TV antenna.
2. Connect the AC adapter.
3. Press the / ON button to turn on the unit.
4. Press the ENTER button.
5. Press the or button to select “Air” or “CATV”, then press the
ENTER button to start auto scan.
6. The unit will immediately search all channels for those with adequate
signal strength and store those channels with signals in memory. The
unit will take a short minutes to finish auto scan and aftter this is
completed, the unit will switch to the first channel found.
ATSC TV mode:
Press the DISPLAY button, the upper window
will pop up, then press the DISPLAY button
again, the lower window will pop up. Press the
DISPLAY button once to exit.
NTSC TV mode:
Press the DISPLAY button, the upper window
will pop up, then press the DISPLAY button
once to exit.
: SELECT
“ENTER” : CONFIRM
Proceed with auto scan ?
No Yes
: SELECT
“ENTER” : CONFIRM
Please select Antenna type.
Air CATV
Manual searching for TV channels
RF CH 13
Press “MENU” To Exit Auto Scan
Found 0
1. Press the MENU button, then press the button to TV CHANNEL
SETTING.
2. Press the button to select ANTENNA. Use the or button to
select AIR or CATV.
3. Use the button to select Auto Scan.
4. Press the ENTER button to enter sub menu of Auto Scan.
5. Use the button to select “Start to Scan” in the sub menu.
6. Press the ENTER button to start the search for TV channels.
7. The screen will show the first received channel when auto search is completed.