Teledyne LeCroy QPHY-HDMI - Manual (Page 36)

Error Messages
These messages may appear when using QualiPHY.
“Warning, no valid technology package has been found…” This message appears if none
of the QualiPHY components have been activated on the oscilloscope before launching the
QualiPHY application.
See Activate Components.
“No devices connected to the application or device not alive…” This message appears if
you are running QualiPHY from a remote PC, but a) you have not connected any oscilloscopes
to the installation, or b) the oscilloscopes are offline. See
Set Up Remote Control to connect an
oscilloscope.
“This test requires Firmware version x.x.x.x or higher.” The test oscilloscope firmware
needs to be updated. Go to teledynelecroy.com/support/softwaredownload under Oscilloscope
Downloads > Firmware Update to download the latest firmware.
“An or better is required for .” The test cannot be run with this
oscilloscope. If using remote control, you may be able to choose another connected
oscilloscope.
“This test requires the option.” Besides installing the QualiPHY software, you must
purchase and activate the named software option on the oscilloscope.
32 922540 Rev A